CTC Union FMUX04 Manual do Utilizador descarregar pdf (Página 40)

Chapter 4. Operation

4-8 Version 1.0b Mar 2003

To modify the Loopback status press "3"

LOCAL <<< Define Port 1 Parameter >>>

Ch A Ch B Ch C Ch D

1. Service ON ON ON ON

2. Line Code HDB3 HDB3 HDB3 HDB3

3. Loopback OFF OFF OFF OFF

============================================================

[ Loopback ]

1. OFF

2. LLB (Local Loopback)

3. NELLB (Near End Local Loopback)

4. RLB (Remote Loopback)

5. RRLB (Request Remote Loopback)

Please select the item or <ESC> to previous menu.

Notice that "ch A" is highlighted, indicating it is the selected channel. Choose the desired loopback

mode from the menu shown or press <ESC> to exit.

If we <ESC> back to the "Define System" menu we can configure the card in Port 2 by pressing

"4". The following will be displayed. Here is the example for the E1 4-channel module. (unbalanced

75?)

LOCAL <<< Define Port 2 Parameter >>>

Ch A Ch B Ch C Ch D

1. Service ON ON ON ON

2. Line Code HDB3 HDB3 HDB3 HDB3

3. Loopback OFF OFF OFF OFF

Please Select Channel A ~ D or <ESC> to previous menu

The service status, Line Code setting, and Loopback mode are displayed for each of the 4 channels.

To change any of the channel settings, select the individual channel with the corresponding letter

A~B~C~D or press <ESC> to exit this menu. For an example of turning on Loopback for Channel

A, press "A". The following menu is displayed.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 59 60

Sem comentários

CTC Union FMUX04 Manual do Utilizador Página 40