CTC Union IPCAM-8309FW Manual do Utilizador descarregar pdf (Página 38)

4.4.5 SMTP

Use the SMTP setting page when you want to send an image via e-mail. By using the Mail

(SMTP) function, you can send a mail with attached image which has been shot triggered by

the external sensor input or with the built-in motion detection function. The image file can also

be sent periodically. E-Mail (SMTP) setting menu is composed of three tabs, General, Alarm

sending and Periodical sending.

4.4.5.1 General

Select On when you wish to use the SMTP function. The common setting options are

displayed below. If you do not wish to use the e-Mail (SMTP) function, select Off and click OK.

Note：

• During transmission of an image file via mail, the frame rate and operation performance

of the monitor image of the main viewer may be reduced.

• While the camera video mode is set to MPEG-4, the image of the composite video

signal output from the video output connector of the camera may be distorted during

mail transmission.

• You cannot send an audio file by using the mail sending function.

SMTP server name：Type the SMTP server name, up to 64 characters, or the IP address of

the SMTP server.

Authentication：Select the authentication method required when you send an email.

Off: Select if no authentication is necessary when an email is sent.

On: When authentication is necessary to send an e-mail, select one of the authentication

methods from the following.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 52 53

Sem comentários

CTC Union IPCAM-8309FW Manual do Utilizador Página 38